Adam works with Autodesk Fusion through the AdamFusion add-in. You can start a task from the panel inside Fusion or use Adam on the web while Fusion and the add-in are running.
Fusion does not use OAuth, an Adam Desktop Connector pairing code, or the Desktop Connector. Install the Fusion add-in only.
Install the add-in
Run the installer
Close Fusion if requested, install AdamFusion, and then restart Fusion.
Open Adam in Fusion
Open a design and select Adam from the Fusion toolbar. Sign in to Adam from the panel if prompted.
Start a narrow task
Ask Adam to describe the active design or selection before requesting a modification. The same task is available in the Adam web app.
Live Fusion access
Fusion must be open and AdamFusion must be running when a task needs live access to the design. If the integration appears offline, open Fusion, load the intended design, and open or run the Adam add-in.
The panel supplies active-document and selection context. Still name important geometry, constraints, and allowed changes in your request; selection alone may not express design intent.
For a risky edit, ask Adam to explain the proposed feature sequence and wait for approval before changing the design.
Reinstall or update
Download the current installer from fusion.adam.new/install and run it again. Restart Fusion after installation so it loads the current add-in.
If the add-in runs but cannot reach Adam, check Adam service status, then sign out and back in from the panel before reinstalling.